Fender Output Transformer, Tone Master

Price: $81.99

Item Number: 026478

Manufacturer: Fender

Quantity:

Fender Tone Master Output Transformer

. FENDER TONE-MASTER CUSTOM SHOP "OUTPUT TRANSFORMER 100W FOR 4/8/16 OHMS", FOR AMPS WITH FOUR 6L6 OUTPUT TUBES, STANDARD UPRIGHT END BELL TYPE, 3.5" BY 2.625" MOUNTING CENTERS. SECONDARY COLOR CODE (4 WIRES): BLACK IS COMMON, THE GREEN/YELLOW STRIPED WIRE IS THE 4 OHM TAP, THE SOLID GREEN WIRE IS THE 8 OHM TAP, THE SOLID YELLOW WIRE IS THE 16 OHM TAP. PRIMARY COLOR CODE: STANDARD RED CENTER TAP WITH BROWN AND BLUE PLATE LEADS (ALSO THERE ARE ADDITIONAL WHITE AND ORANGE WIRES EXITING FROM THE PRIMARY SIDE HOLE BUT THE TONE-MASTER SCHEMATIC SHOWS NO CONNECTIONs FOR THESE-PERHAPS THIS TRANSFORMER WAS USED IN OTHER HIGH POWER FENDER AMPS?). ONE OF OUR ESTEEMED CUSTOMERS, MARK WHITNEY, WRITES: "...the Tonemaster output transformer was also used earlier in the red knob The Twin. The orange and white pair were for a low level unbalanced XLR out." Our customer ED SMITH WRITES: "Thought I would add one more point on the extra output taps. I noticed the comment from your esteemed customer stating that those taps were used for a balanced output on "The Twin". That's absolutely correct the only thing I would add is the white wire is the "in Phase" signal (pin 2 on an XLR jack) and the Orange wire is the "Out of Phase" signal (pin 3 on an XLR jack). Fender typically left pin 1 open on those. Someone might consider adding a ground lift function dependent on the application. Fender listed that connection as a +3dB level." NICE IRON FOR BUILDING POWERFUL 6L6 AMPS WITH MULTIPLE OUTPUT IMPEDANCES? GENUINE FENDER PART #026478.